Checklist

Last updated In Knitting

Before you start knitting, always check the following:

Software

  • Selected correct feeders for waste yarn, draw thread, and knitting yarn
  • Speed, stitch size, and roller take-down adjusted to yarn and pattern
  • Right program loaded on the SD card and named 'command.kc'

Machine

  • All needles are in good condition
  • All parts are properly lubricated, oily to touch
  • Needle beds are clean of any debris, yarns, etc
  • Doors are closed
  • No machine errors; no error lights
  • SD card with ‘command.kc’ file inserted
  • All yarns are threaded in the correct paths
  • All yarn positions match with the programmed feeders
  • No yarns are crossing
  • Tension settings are right
  • Knot sensor set right
  • Enough yarn on the cones to knit your program
  • All yarns are clamped
  • All used feeders are positioned between the clamp and the needle bed
  • Any feeders that aren’t used are placed on the far left of the bed

In case you are making your final piece:

  • Have made a successful tension swatch and sample with this yarn before knitting your piece
  • Make sure all sizes are correct