Machine errors

Last updated In Knitting

Error codeError locationIndication light

FRONT DOOR

(DOOR FL/ DOOR FR)

Front doors both left and right:

  • make sure doors are well closed (the red led near the door magnet should be lit up)
No

REAR DOOR

(DOOR RL/ DOOR RR)

Rear doors both left and right:

  • make sure doors are well closed (the red led near the door magnet should be lit up)
No

SIDE DOOR

(DOOR SIDE)

Side panels on machine both left and right:

  • make sure they are well connected (the red led near the connector should be lit up)
No
SHOCK

Front or rear needle bed:

  • make sure needles are in good state and can move up and down smoothly
  • check jacks are in a good state and well aligned (not sticking out at the bottom).
  • If there are any broken needles or jacks, make a good inspection to make sure there are no small pieces like butts lying around anywhere near the needle bed.
No
CLUMP

Next to brushes on carriage:

  • clear or push down the float triggering the sensor and make sure the metal piece is in a vertical position
Yes
ROLLER

Under needle beds:

  • pull the fabric a little
  • make sure there is no yarn tangled in the rollers
Yes

YARN TOP

(YARN T)

Tension arm on top yarn control unit:

  • pull the yarn from the cone's end to set back tension
  • rethread in case the yarn is broken or finished
  • adjust tension if necessary

Knot sensor:

  • check the yarn for knots
  • move the metal latch to the original position
Yes

YARN SIDE

(YARN S)

Tension arm on lateral yarn control unit:

  • check for possible broken yarn and rethread
  • reset tension with pink sliders if necessary
Yes