Taking off the side panels and placing them back
To be able to carry the machine without damaging it, you need to take off the side panels.
How to take off the side panels
- Unscrew the silver screw at the top of the panel, which you can do by hand.

- Once the screw is off, tilt slightly the panel towards you and pull it upwards
to remove it from the two hooks at the bottom of the panel.
Note: For the left panel, on which the side yarn control unit is located, disconnect
the sensor before pulling the panel upwards.
How to place the side panels back
- Hold the panel slightly tilted and place its bottom slots into the hooks below
the handles of the machine. - Once the panel is inserted in the hooks, hinge it forward to close it.
- Mount the panel into the piece where the thumb screw can secure the
panel. - Lock the panel by tightening the thumb screw by hand.
Note: For the left panel, don't forget to reconnect the sensor before closing the panel completely.