Skip to content
KniterateSupport
  • Help centre
  • Community
  • Contact
Sign in
  1. Help centre
  2. Software: Customist Studio
  3. Create a design: Workflow
  4. 7. Knit!

7. Knit!

Last updated 21 September 2026In Create a design: Workflow

Click Knit! and save the resulting file on your SD card with the name “command.kc”.

Always replace the file that's previously on the card. Remember the card can only contain one command.kc file for the machine to read it properly.

Was this article helpful?

Previous6. Settings

Articles in Create a design: Workflow

  • 1. Create your pattern
  • 2. Insert the Waste and Cast-on section
  • 3. Generate shaping transfers
  • 4. Finishing steps
  • 5. Check the program for errors
  • 6. Settings
  • 7. Knit!
KniterateSupport

Help articles, manuals and the community for the Kniterate digital knitting machine and Customist.

Support

  • Help centre
  • Community
  • Contact support
  • support@kniterate.com

Kniterate

  • kniterate.com
  • Customist
© 2026 KniterateThis site stores no tracking cookies. Signing in sets a session cookie only.