Needles don't pick up the thread

Hello, we have a new Kniterate knitting machine and are trying to knit our first scarf. The pattern is from Kniterate itself. It came with the machine on an SD card. The file is already named command.kc, so we can't open it in the Kniterate design app. This means we can't adjust anything, for example, the stitch size. Because it was supplied by Kniterate itself, you'd think the settings would be correct and that only the knitting machine itself needs to be adjusted, such as thread tension. We've tried a lot with the thread tension, but we haven't managed to knit a scarf yet. The waste yarn is knitted, but as soon as it starts the cast-on, it goes wrong. The thread for the cast-on is carried by the carrier, but the needles don't pick it up. It floats above the needle beds, so the machine jams. We've already lowered the feeder as much as possible, but the problem persists. Does anyone know of this problem and a solution?

4 replies

  1. Ariadna PonsOfficial reply

    Hi @Racer,

    I hope you are well.

    The file that comes in the SD card with the machine is not the scarf, but the warm-up file. The scarf file is available for download from the shared drive folder.

    You are right, the scarf file can't be opened in the app, since we don't have a .buck or .json file for it, unfortunately. It was created a long time ago, even before the app existed. Therefore, the settings cannot be adjusted in the software.

    The file settings are correct for a specific yarn. This is normal, as each yarn requires its own settings.

    Could you please share the type of yarn you are using? Which of the yarn feeders is failing to knit? How are you holding the yarns before you start knitting? Can you share a video of the problem?

    Looking forward to hearing back from you.

    Thanks!

  2. Hello Ariadna,

    Thank you very much for your answer!

    We ended up setting the thread tension as low as possible everywhere and we got the best result so far. The scarf is knitted, but there are still a few gaps between the waste yarn and the cast on. We use 7Nm cotton as yarn. Do you have any idea why we keep those gaps, even though the rest of the scarf is knitted properly?

  3. Ariadna PonsOfficial reply

    Hi @Racer,

    Could it be that the draw thread was not correctly caught by the first needles at its introduction?

    Could you please send a picture of the knit?

    If this is the problem, please make sure you catch the yarns as shown in this video before you start a knit:

    https://www.loom.com/share/25f94b0b6a7f46fb923e6ba3a9739ea5

  4. polersss

    thanks

Add a reply

Sign in to reply. Your Kniterate account works here: the same e-mail and password as customist.com, or Google.