Feeders hitting and breaking needles?
I've been having consistent problems with broken needles, where the latch itself ends up too bent to open and close correctly or, in a few cases, actually breaks off completely. It doesn't happen with every swatch, but it happens very often. It also happens regardless of what type of stitch I'm attempting, from simple to complex, and no matter what yarn I use.
I tried setting the height and position of the yarn feeders as described in this article, but this led to feeders regularly hitting needles during knitting (with audible collision sounds and occasional needles bending and breaking). There was another article I found at some point about setting the feeder height (I can't find it again right now) that described setting the feeders to be 0.5mm from the needles in each bed, and when I tried that I ended up with problems actually forming stitches because the yarn fed much too high.
Is there another aspect here that I'm missing? I'm not sure what else might be wrong, except that I once (while knitting very slowly to watch the stitches) caught the carriage pushing a carrier along the rail not by the center, but by the back slope portion of the carrier bow. This caused the feeder to misalign with the needes trying to form stitches. It was only halfway down the knit panel that the carriage finally locked into the carrier bow properly, and it caused tons of missed stitches and a few collisions. I was running very slow though, so maybe that was the issue in this particular case?
I'm hoping somebody has advice on what I might be missing, since this has been a huge frustration and I really have no idea what I'm doing wrong.










